Charcoal Slate Ledge Wall

Bring the cool sophistication of stacked stone to your space—without the weight, mess, or permanence. Charcoal Slate Ledge Wall is a removable wallpaper designed to mimic natural slate in deep charcoal tones, adding depth, texture, and modern character to living rooms, bedrooms, entryways, and feature walls.

Every roll is PVC-free and printed with eco-friendly, water-based inks for a low-odor, indoor-safe finish you can feel good about.

Key Features

• Realistic charcoal slate ledge design with rich detail and a soft, matte finish
• Removable and renter-friendly for an easy style refresh without wall damage
• PVC-free substrate printed with eco-friendly, water-based inks
• Each roll is 24 inches wide and available in heights up to 120 inches
• Works best on smooth, clean, properly primed and painted walls
• Low-odor, durable print that wipes clean

What’s Included

• 1 removable wallpaper roll, 24 in wide x your selected height (up to 120 in)
• Simple installation guide

Sizing & Coverage

• Roll width: 24 in (61 cm)
• Roll height: select up to 120 in (305 cm) to suit your wall
• To estimate quantity: measure your wall width in inches and divide by 24, then round up and add 1 extra roll for trimming and pattern alignment.

Installation Guidance

1. Prepare the surface: Walls must be smooth, clean, dry, and fully cured (allow freshly painted walls to cure for at least 30 days).
2. Plan your layout: Mark a plumb vertical line for your first roll. Unroll and check panel order for pattern flow.
3. Apply and smooth: Starting at the top, align the edge with your plumb line and smooth downward with a felt squeegee, working out air bubbles as you go.
4. Match and butt seams: Install subsequent rolls edge-to-edge (do not overlap) and align the slate pattern.
5. Trim and finish: Use a sharp blade to trim along ceilings, baseboards, and outlets. Replace blades often for crisp cuts.

Tips: Two-person installation is recommended. Avoid installing on textured walls, high-moisture areas with frequent steam, or over stain-resistant/low-VOC paints that can affect adhesion. Always test a small area first.

Care Instructions

• Wipe gently with a soft, damp cloth; use mild soap if needed.
• Avoid abrasive scrubbers, harsh chemicals, or excessive moisture.
• To remove, peel slowly from a corner at a 180° angle. If resistance is felt, warm the area slightly and continue.

Note: Color may vary slightly by screen. For best results, order all rolls at the same time to ensure a consistent print run.