Urban Brutalist Facade

Bring architectural drama to your space with a removable wallpaper inspired by raw concrete, bold geometry, and the timeless edge of Brutalist design. Urban Brutalist Facade delivers a modern, gallery-ready backdrop that’s renter-friendly and made with materials you can feel good about.

Key Features

• Removable and renter-friendly: Refresh your walls without damage or residue on most properly painted, smooth surfaces.
• Eco-conscious production: PVC-free substrate printed with eco-friendly, water-based inks for low-odor indoor use.
• Striking modern aesthetic: Architectural textures and clean lines create depth and character in living rooms, bedrooms, offices, and entryways.
• Flexible sizing: Rolls are 24 inches wide and available in heights up to 120 inches for floor-to-ceiling coverage.
• Matte, photo-friendly finish: Minimizes glare and enhances pattern detail.

Sizing and Coverage

Each roll measures 24 inches wide and up to 120 inches high. Measure your wall width, then divide by 24 inches to estimate the number of panels needed. Add one extra panel for pattern alignment and trimming around corners or obstacles.

Installation Guidance

1. Prep the wall: Ensure the surface is smooth, clean, dry, and fully cured (allow at least 30 days for freshly painted walls). Avoid heavy texture and high-moisture areas.
2. Plan your layout: Mark a straight, plumb line for the first panel. This keeps all subsequent panels aligned.
3. Apply the first panel: For peel-and-stick: Peel 6–12 inches of backing, align at the top, and smooth downward with a felt squeegee, peeling more liner as you go. For paste-the-wall: Roll adhesive on the wall per paste instructions, then apply and smooth the panel.
4. Smooth and align: Use a felt-edge tool to remove air pockets from the center outward. Butt-join edges carefully and match the pattern without overlapping.
5. Trim and set: Use a sharp utility knife to trim excess at the ceiling, baseboards, and outlets. Press seams firmly and allow 24 hours to set.

Care and Maintenance

• Wipe gently with a dry or slightly damp microfiber cloth.
• Avoid abrasive scrubbers, bleach, and solvent-based cleaners.
• Keep away from direct water contact and prolonged steam.
• To remove, peel slowly at a 180-degree angle. If resistance occurs, warm the panel slightly and continue peeling.

Note: Color may vary slightly between batches; order all panels at once for best consistency. Test a small area on your wall to confirm adhesion and clean removal.