Whimsical Panda Hammock Haven

Drift into a playful, peaceful vibe with Whimsical Panda Hammock Haven, a removable wallpaper that brings lounging pandas and soft, storybook charm to nurseries, kids’ rooms, reading nooks, and cozy corners. Printed on a premium PVC-free material with eco-friendly, water-based inks, it delivers a beautiful finish you can feel good about.

Key Features

• Removable wallpaper for stress-free, renter-friendly makeovers.
• Panel size: 24 inches wide; select heights up to 120 inches for floor-to-ceiling coverage.
• Seam-matching design prints in aligned panels for a continuous look.
• Matte finish for crisp detail and reduced glare.
• PVC-free substrate printed with eco-friendly, water-based inks.
• Best on smooth, properly painted and primed walls; removes cleanly when installed as directed.

Sizing and Coverage

Each roll is supplied as a 24-inch-wide panel. Choose a height up to 120 inches to match your wall, then trim excess during installation.

• Measure your wall width in inches and divide by 24, then round up to get the number of panels needed.
• Select a panel height equal to or slightly taller than your wall height for a perfect edge-to-edge fit.
• For consistent color and pattern alignment, order all panels for a wall in one purchase.

Installation Guidance

1. Ensure walls are smooth, clean, dry, and fully cured if recently painted (typically 30 days).
2. Wipe away dust and mark a plumb line to keep the first panel perfectly straight.
3. Starting at the top, apply the first panel, smoothing from the center outward to remove air bubbles.
4. Butt the next panel edge-to-edge, align the pattern, and continue smoothing downward.
5. Trim excess at the ceiling, baseboard, and around outlets with a sharp blade.
6. To remove, gently peel back at a low angle, pulling slowly and evenly.

Note: Install on smooth, non-textured walls. Avoid high-moisture areas like steamy bathrooms or surfaces exposed to direct heat.

Care Instructions

• Dust regularly; spot clean with a soft, damp cloth.
• If needed, use mild soap and water; avoid abrasives, bleach, and strong solvents.
• Do not saturate with water; avoid excessive humidity to preserve adhesion and print quality.