Bring quiet luxury to your space with Whispering Gold Satin Waves, a removable wallpaper that flows across your walls in soft, shimmering curves. Designed for renters and refreshers alike, it installs cleanly and removes with ease. All our wallpapers are PVC-free and printed with eco-friendly, water-based inks for a beautiful, low-impact finish.
Key Features
Removable, renter-friendly wallpaper for effortless home decor updates
PVC-free material printed with eco-friendly, water-based inks
Roll size: 24 inches wide; choose heights up to 120 inches
Smooth, matte surface minimizes glare and highlights the design
Repositionable during installation for easy alignment
Suitable for smooth, clean, painted walls, doors, and furniture accents
Sizing and Coverage
Each roll is 24 in (2 ft) wide and up to 120 in (10 ft) high.
Maximum coverage per roll: approximately 20 sq ft.
Measure your wall width and divide by 24 in to estimate the number of rolls; round up for full coverage.
Example: A 12 ft (144 in) wide wall typically needs 6 rolls (144 Γ· 24 = 6).
Add a small margin for trimming and pattern alignment.
Installation Guidance
Prepare: Ensure walls are smooth, dry, and dust-free. Freshly painted surfaces should cure for at least 30 days.
Plan: Mark a level, vertical guideline to keep the first roll perfectly plumb.
Apply: Peel a few inches of backing, align the top, and press onto the wall. Continue peeling and smoothing downward.
Smooth: Use a felt squeegee or soft cloth to remove air bubbles, working from the center outward.
Align: Overlap edges slightly as needed and match the wave pattern carefully.
Trim: Use a sharp utility knife to trim along ceilings, baseboards, and around outlets.
Care and Maintenance
Wipe gently with a soft, damp cloth; use mild soap if needed.
Avoid harsh cleaners, bleach, and abrasive scrubbers.
Best for dry, low to moderate humidity areas; ensure good ventilation in bathrooms.
Not recommended for textured walls, heavy moisture, or areas with direct water contact.
Removal
Peel slowly from a top corner at a low angle (close to 180Β°) to release the adhesive.
If resistance occurs, warm gently with a hair dryer on low heat and continue peeling.
Adhesive residue is uncommon; if present, remove with mild soapy water.
Note: Colors may vary slightly by lighting and screen settings. For best results, order enough rolls at one time to ensure a consistent print run.
