Invite a storybook serenity into your space with Enchanted Aviary Garden. This removable wallpaper pairs graceful birds with lush botanical motifs to bring a timeless, nature-inspired ambiance to any roomβperfect for renters and long-term homes alike. Every roll is PVC-free and printed with eco-friendly, water-based inks for a beautiful, low-odor finish you can feel good about.
Key Features
Removable design: Created for easy installation and clean removal from most properly painted, smooth walls.
Eco-conscious: PVC-free substrate and water-based inks.
Precision sizing: Each roll is 24 inches wide and available in heights up to 120 inches for a tailored fit.
Seam-friendly pattern: Consistent alignment for a cohesive, polished look.
Low-odor printing: Water-based inks help keep indoor air fresh during installation.
Size & Coverage
Each roll measures 24 inches (61 cm) wide and up to 120 inches (305 cm) high. Measure your wall height and select the closest roll height; add 2β3 inches to allow for trimming at the ceiling and baseboard.
Estimate quantity: total wall width (in inches) Γ· 24 = number of rolls needed. Add 10% for pattern matching and trimming.
Works best on smooth, clean, and fully cured painted surfaces (allow new paint to cure for 30 days).
Installation Guidance
Suitable for smooth, non-textured, clean, and dry walls. Avoid areas with heavy moisture or direct water contact.
Prep the wall: Wipe with mild soap and water, rinse, and let dry completely. Remove dust, nails, and switch plates.
Mark a plumb line: Use a level to draw a straight vertical line to guide your first roll.
Apply the first roll: Align to the plumb line. For self-adhesive material, peel a small section of backing and smooth downward as you go. For paste-the-wall material, apply a thin, even coat of wallpaper adhesive per manufacturer directions and hang the roll.
Match and seam: Hang the next roll edge-to-edge (do not overlap), aligning the pattern. Smooth firmly to remove air bubbles.
Trim and finish: Use a sharp blade to trim excess at ceilings, baseboards, and around fixtures. Change blades often for clean cuts.
Removal tip: Warm gently with a hair dryer on low and peel slowly at a 180Β° angle.
Care Instructions
Wipe with a soft, damp cloth; use mild, non-abrasive soap if needed.
Avoid bleach, solvents, and abrasive pads.
Not recommended for textured walls, fresh paint under 30 days, or high-moisture zones (e.g., inside showers or splash zones).
Always test a small area for adhesion and removability before full installation.
