Artisan Weave in Soft Fawn

Artisan Weave in Soft Fawn

Bring quiet texture and warmth to your space with Artisan Weave in Soft Fawn. This removable wallpaper features a subtle, woven-inspired pattern in a soft neutral tone that complements modern, classic, and minimalist interiors. Thoughtfully crafted for home decor, it delivers an elevated, textile look without permanent commitment.

Materials & Sustainability

All our wallpapers are PVC-free and printed with eco-friendly, water-based inks for a low-odor, home-safe finish you can feel good about.

Key Features

• Removable, renter-friendly wall covering designed for smooth, properly prepared walls
• Rolls measure 24 inches wide and are available in heights up to 120 inches
• Matte finish minimizes glare and highlights the artisan weave detail
• Digitally printed for crisp texture and consistent color
• Ideal for accent walls, full rooms, and statement niches

Choosing Your Size

1. Measure your wall height to select a panel (roll) height up to 120 inches.
2. Measure your wall width and divide by 24 inches to estimate how many panels you need. Always round up.
3. Consider ordering an extra panel to allow for trimming and pattern alignment.

Example: A 10-foot (120-inch) wide wall typically requires 5 panels of 24 inches each.

Surface Prep

• Install on smooth, clean, dry, and fully cured painted surfaces.
• Remove dust and grease; repair and sand imperfections for best adhesion and finish.
• A quality primer can improve results, especially on porous or freshly painted walls.
• Not recommended for heavy texture, high humidity, or areas with direct water exposure.

Installation Guidance

1. Use a level to mark a plumb starting line.
2. Align the first 24-inch panel to your line and smooth from the center outward with a felt squeegee or soft cloth.
3. Install subsequent panels edge-to-edge, carefully aligning the pattern. Avoid stretching the material.
4. Trim excess at the ceiling, baseboard, and around outlets using a sharp blade.
5. For best results, install with two people and replace blades frequently for clean cuts.

Care Instructions

• Wipe with a soft, damp microfiber cloth; a small amount of mild soap may be used if needed.
• Avoid abrasive scrubbers, bleach, and solvent-based cleaners.
• Test any cleaner on a small, inconspicuous area first.

Note: Color may vary slightly by screen. For optimal results, confirm surface readiness and order sufficient panels for your project.