Gilded Monstera Leaf Tapestry

Gilded Monstera Leaf Tapestry

Bring botanical glamour to your space with a removable wallpaper that blends lush monstera leaves with a gilded-inspired look. Designed for renters and homeowners alike, this wall covering installs cleanly, removes without damage, and is crafted with PVC-free materials and eco-friendly, water-based inks.

Key Features

• Removable wallpaper: Easy to install and cleanly removable for refreshes or moves.
• Eco-conscious: PVC-free and printed with eco-friendly, water-based inks.
• Roll sizing: Each roll is 24 inches wide and available in heights up to 120 inches.
• Seamless look: Designed to align across multiple rolls for a continuous pattern.
• Versatile style: Ideal for accent walls, full rooms, home offices, nurseries, and entryways.

Sizing & Coverage

Measure your wall width and divide by 24 inches to estimate how many rolls you need. For example, a 96-inch-wide wall generally needs 4 rolls. Choose a height up to 120 inches to match your wall. For best results, add a small margin for trimming and pattern alignment.

Surface Compatibility

• Best on smooth, clean, and fully cured painted walls (eggshell or satin finishes recommended).
• Not recommended for textured walls, brick, concrete, raw wood, or surfaces with moisture or grease.
• Allow fresh paint to cure for at least 30 days before installation.
• Test a small, inconspicuous area first to confirm adhesion and removability.

Installation Guidance

1. Prepare the wall: wipe clean, dry thoroughly, and remove outlet covers and hardware.
2. Mark a level vertical guideline where your first panel will hang.
3. Starting at the top, peel back 8–12 inches of the liner and align the panel to the guideline.
4. Smooth downward with a felt squeegee or soft cloth, working from center outward to remove air bubbles.
5. Continue peeling the liner in sections, smoothing as you go. Avoid stretching the material.
6. Hang subsequent panels edge-to-edge or with a slight overlap as needed for a seamless pattern; trim excess at ceiling, baseboard, and around fixtures with a sharp knife.
7. Allow 24 hours for the adhesive to set.

Care Instructions

• Wipe gently with a soft, damp, lint-free cloth.
• For tougher marks, use mild, dye-free soap; rinse and dry immediately.
• Avoid harsh cleaners, bleach, abrasives, and excessive scrubbing.
• Keep away from direct water spray, heavy steam, and high heat sources.

Removal

Lift a corner and peel back slowly at a low angle. If needed, slightly warm the panel with a hair dryer on low to ease release.